bon hier je disait que "r56" n'est pas utile pour un vr sensor; elle est la pour pouvoir lire un hall sensor avec le même circuit...
cepandant une modification mentionné ici: http: //www.megamanual.com/ms2/vradjust.htm peut rendre ce potentiomètre utilisable.
You can improve the common-mode rejection of the circuit (common mode rejection is the ability of the circuit to 'ignore' the effects of noise that occurs on both signal wires at the same time). Here is the first thing to try: take the VR return wire, the one you have been connecting to ground, and put in a series resistance, like 47K or so, and connect the other end of the resistor directly to the wiper of the zero-crossing potentiometer (R56), marked "2 2" in the schematic below, which also goes to the base of Q23 (the "2 2" indicates pin 2 on the pot and pin 2 on Q23). Next move the zero-crossing point potentiometer setting off of zero volts to a point of, say 1 volt or even higher (measure the voltage at the wiper). Since the return point of the VR is also at this junction, the VR sensor will also be biased up the same amount, so the circuit will still sense zero crossing properly. In fact, it does not matter where the zero-crossing pot is set in this case, since the return VR sensor lead will also be biased by the same amount. But what this does is allow rejection of common noise introduced in the VR wires by the op-amp.
J'ai pas testé cette modification parce que j'en ai pas eu besoin. La théorie c'est que ca donne un circuit qui est insensible aux bruit qui arrive au ms par les deux fil du vr simultanément; tout en restant sensible au signal, qui lui est une différence de potentiel entre les deux fil.
Ça éliminerais donc les bruit causé par le couplage capacitif (quand un fil de gros courant côtoie les fil du vr)
Je vais quand même le tester pour la forme et je vous donnerez des news